Ryobi RY52003 Bedienungsanleitung

OPERATOR’S MANUALTP30 GAS PRUNERRY52003SAVE THIS MANUAL FOR FUTURE REFERENCEYour pruner has been engineered and manufactured to Ryobi’s high standard

10 11WARNING: Do not allow familiarity with tools to make you care-less. Remember that a careless fraction of a second issufficient to inflic

10 11OPERATIONFig. 7CUTTING GUIDEFig. 6n Release the trigger as soon as the cut is completed, allow-ing the engine to idle. If you run the pruner at

12 13STOPOPERATIONHALF CHOKE (B) FULL CHOKE (A)RUN (C)CHOKE LEVER Fig. 12POSITION FOR STARTINGSee Figure 9.Lay the pruner on the ground and ensure th

12 13MAINTENANCEFLATSAPPROX .050 IN. (1.25 mm)Fig. 14Fig. 13WARNING:When servicing, use only identical Ryobi replacement parts. Use of any o

14 15MAINTENANCEREPLACING THE BARSee Figures 15 - 20.WARNING: To avoid possible serious injury, stop engine before re-placing the bar, chain, or perfo

14 15STOPMAINTENANCECHAIN OILERSee Figure 22.n Use Premium Bar and Chain Oil. It is designed for chains and chain oilers and is formulated to perfor

16 17MAINTENANCECHAIN MAINTENANCESee Figure 23.For smooth and fast cutting, the chain needs to be main-tained properly. The following conditions indic

16 17MAINTENANCECAUTION:Dull or improperly sharpened chain can cause excessive engine speed during cutting which may result in severe engine damage.WA

18 19FUEL CAPWARNING: A leaking fuel cap is a fire hazard and must be replaced immediately.The fuel cap contains a non-serviceable filter and a check

18 19TROUBLESHOOTINGPROBLEM CAUSE REMEDYEngine will not start. No spark.No fuel.Engine is flooded.Starter rope pulls harder now than when new.Check

2 3n Introduction ...

20 21WARRANTYRYOBI TECHNOLOGIES INC. LIMITED WARRANTY FEDERAL AND CALIFORNIA EMISSION CONTROL SYSTEMS NONROAD AND SMALL OFF-ROAD ENGINESThe U.S. Envir

20 21EMISSIONS MAINTENANCE SCHEDULE AND WARRANTED PARTS LISTEmissions Parts Inspect Before Clean Every

983000-637 2-05OPERATOR’S MANUALTP30 GAS PRUNERRY52003 WARNING:The engine exhaust from this product contains chemicals known to the State of

2 3WARNING!Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious pe

4 5n Kickback is a dangerous reaction that can lead to serious injury. Kickback may occur when the moving chain con-tacts an object at the upper porti

4 5SYMBOLSGasoline and OilUse unleaded gasoline intended for motor vehicle use with an octane rating of 87 [(R + M)/2] or higher. This product is powe

6 7SYMBOLSSERVICEServicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service we

6 7FEATURESFig. 1PRODUCT SPECIFICATIONSEngine Displacement ...

8 9Fig. 2CLAMPFLAT WASHERLOCK WASHERLONG BOLTCLAMPSHORT BOLT“J” BARRIERHANDLEWARNING:To prevent accidental starting that could cause serious personal

8 9n Pull apart the ends of the bracket to expand slightly.n Slide the bracket over the power head shaft immediately behind the “J” Barrier Handle.