Ryobi 775r Bedienungsanleitung

FOR QUESTIONS, CALL 1-800-345-8746 in U.S. or 1-800-265-6778 in CANADAwww.ryobi.comIMPORTANT MANUAL DO NOT THROW AWAYOPERATOR’S MANUAL2-Cycle Gas Trim

5. Tighten the clamp screws evenly until the J-handle is secure.ASSEMBLY INSTRUCTIONS104. While holding the unit in the operatingposition (Fig. 6), po

ASSEMBLY INSTRUCTIONS11INSTALLING THE CUTTINGATTACHMENT SHIELDUse the following instructions if the cuttingattachment shield on your unit is not insta

OIL AND FUEL INFORMATION12WARNING: Gasoline is extremelyflammable. Ignited Vapors mayexplode. Always stop the engine andallow it to cool before fillin

STARTING/STOPPING INSTRUCTIONS134. Place the choke lever in the FULL chokeposition (A) (Fig. 11).8. If the engine does not start, repeat steps 4 throu

OPERATING INSTRUCTIONS142. While firmly holding the add-on, push itstraight into the Click-Link®coupler (Fig. 14).NOTE: Aligning the release button wi

OPERATING INSTRUCTIONS15Each time the head is bumped, about 1 in. (25.4 mm.) of trimming line is released. A blade in the cutting attachment shield wi

FREQUENCY MAINTENANCE REQUIRED REFER TO:Before Starting Engine Fill fuel tank with correct oil and fuel mixture. Page 12Every 10 Hours Clean and re-oi

MAINTENANCE AND REPAIR INSTRUCTIONS177. Repeat procedures 4-6 with the secondpiece of line.Line Locking HoleTrimming LineLine Loading HoleEyelet5. Ins

MAINTENANCE AND REPAIR INSTRUCTIONS18Bump KnobFoam SealSpringInner ReelInstalling a Prewound Inner reel1. Remove the bump knob, spring, and foamseal b

MAINTENANCE AND REPAIR INSTRUCTIONS19AIR FILTER MAINTENANCERemoving the Air Filter/Muffler CoverWARNING: To avoid seriouspersonal injury, always turn

THANK YOUThank you for buying this quality product. Thismodern outdoor power tool will provide manyhours of useful service. You will find it to be agr

MAINTENANCE AND REPAIR INSTRUCTIONS206. Replace the air filter in the air filter/muffler cover (Fig. 32).NOTE: Operating the unit without the air filt

MAINTENANCE AND REPAIR INSTRUCTIONS21CARBURETOR ADJUSTMENTThe idle speed of the engine is adjustablethrough the Air filter/Muffler cover (Fig. 36).NOT

MAINTENANCE AND REPAIR INSTRUCTIONS22REPLACING THE SPARK PLUGUse a Champion RDJ7Y spark plug (or equivalent). The correct air gap is 0.020 in.(0.5 mm.

CLEANING AND STORAGE23TRANSPORTING• Allow the engine to cool before transporting. • Secure the unit while transporting.• Drain fuel from unit.• Tighte

TROUBLESHOOTING24Engine will not startEngine will not idleLow idle speedEngine will not accelerateEngine lacks power orstalls when cuttingCutting head

SPECIFICATIONS25ENGINEEngine Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Air-Coole

NOTES26

27The California Air Resources Board and RyobiOutdoor Products (ROP), are pleased to explainthe emission control system warranty on your1995 and later

RYOBI OUTDOOR PRODUCTS warrants each newRYOBI Product for two (2) years according to thefollowing terms.This warranty extends to the original retail p

WARNING!3SPARK ARRESTORWARNINGCALIFORNIA EMISSION REGULATIONSNOTE: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Wa

RULES FOR SAFE OPERATION4• Clear the area to be cut before each use.Remove all objects such as rocks, brokenglass, nails, wire, or string which can be

RULES FOR SAFE OPERATION5• Always stop the engine and allow it to coolbefore filling the fuel tank. Never remove thecap of the fuel tank, or add fuel,

RULES FOR SAFE OPERATION6OTHER SAFETY WARNINGS• Never store the unit, with fuel in the tank,inside a building where fumes may reach anopen flame or sp

RULES FOR SAFE OPERATION7• THROWN OBJECTS AND ROTATING CUTTER CAN CAUSE SEVERE INJURYWARNING: Do not operate without the cutting attachmentshield in p

RULES FOR SAFE OPERATION8KNOW YOUR UNITAPPLICATIONUse this unit for; • Cutting grass and light weeds.• Decorative trimming around trees, fences, etc.O

ASSEMBLY INSTRUCTIONS9INSTALLING AND ADJUSTING THED-HANDLE - MODEL 767r1. Push the D-handle down onto the shafthousing so that the handle slants towar