Ryobi ELL0001 Betreibershandbuch PDF herunterladen (Seite 11)

10

11

OPERATION

ROUGH SURFACE ADAPTOR

See Figure 6.

Using the rough-surface adaptor, you can use

the laser level’s AIRgrip

™

feature to positon the

unit on many non-smooth surfaces, including

brick and painted cinderblock.

NOTE: The AIRgrip

™

feature cannot be used

with stucco or unpainted cinderblock.

n Position the rough-surface adaptor on the

surface where you want to secure the laser

level.

NOTE: The dotted lines on the adaptor

should be visible.

n Place the laser level against the adaptor

on the dotted lines, and push in slightly to

engage the seal.

n Continue to hold the laser level against the

surface while pressing the on/off switch.

n Release the laser level when you hear a

change in motor sound.

USING MULTI-FUNCTION BASE

See Figure 7.

Velcro

®

strap, push pin, and tripod mounting

methods are available only when the multi-

function base is installed. To install the base:

n While holding the laser level with the power

switch facing you, align the raised ridge on

the base with the groove on the level.

n Slide the laser level and base completely

together.

NOTE: If the base is seated correctly, the

vacuum will not operate when the power

is turned on.

VELCRO

®

STRAP: The strap can be used

to attach the laser level to irregularly shaped

Fig. 6

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare