Ryobi CSB135L Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 10)

10 - English

OPERATION

STARTING/STOPPING THE SAW

See Figure 9, page 16.

To start the saw: Depress the switch.

Always let the blade reach full speed, then guide the saw

into the workpiece.

WARNING:

The blade coming in contact with the workpiece before

it reaches full speed could cause the saw to “kick back”

towards you resulting in serious injury.

To stop the saw: Release the switch.

After you release the switch, allow the blade to come to a

complete stop. Do not remove the saw from the workpiece

while the blade is moving.

ADJUSTING BLADE DEPTH

See Figure 10, page 16.

Always keep correct blade depth setting. Less than a full tooth

of the blade teeth should be visible below the workpiece.

More blade depth will increase the chance of kickback and

cause the cut to be rough. For more depth of cut accuracy,

a scale is located on the upper blade guard.

To adjust the blade depth:

Unplug the saw.

Pull depth lock lever upward to release. The depth lock

lever is located between the guard and handle of the saw.

Determine the desired depth of cut.

Locate depth of cut scale and index point on back of

upper blade guard.

Hold base flat against the workpiece and raise or lower

saw until the index point (or reference mark) on bracket

aligns with notch on blade guard.

Push down on the depth lock lever to lock the lever in

place and secure the position.

USING THE LASER GUIDE

See Figure 11, page 16.

WARNING:

Do not stare into the laser beam or turn the laser on when

the tool is not in use. Failure to heed this warning could

result in possible serious personal injury.

The laser unit comes from the factory already installed and

aligned. If the laser becomes misaligned after time refer to

the Adjustments section.

NOTE: Make a trial cut on a piece of scrap to ensure laser

is aligned. Adjusting the laser may be necessary.

 Mark the line to be cut on the workpiece.

 Adjust the depth and angle of the cut as needed and lock

the depth and bevel settings.

 Connect the saw to a power supply.

 Depress the switch to start the motor. The laser guide will

turn on when the switch is depressed and turn off when

the switch is released.

NOTE: Do not touch the blade to the workpiece until the

saw has reached maximum speed.

 Slowly push the saw forward into the workpiece.

NOTE: Keep the laser beam on the marked line on the

workpiece for precision cutting.

 Once the cut is complete, allow the saw to come to a

complete stop. The laser will turn off when the switch is

released.

OPERATING THE SAW

See Figures 12 - 14, page 17.

It is important to understand the correct method for operat-

ing the saw. Refer to the figures in this section to learn the

correct and incorrect ways for handling the saw.

WARNING:

To make sawing easier and safer, always maintain proper

control of the saw, by holding the saw with both hands.

Loss of control could cause an accident resulting in pos-

sible serious injury.

DANGER:

When lifting the saw from the workpiece, the blade is

exposed on the underside of the saw until the lower blade

guard closes. Make sure the lower blade guard is closed

before setting the saw down.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Ryobi CSB135L Gebrauchs- und Pflegehandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Ryobi CSB135L