Ryobi BD4600 Betreibershandbuch

1THANK YOU FOR BUYING A RYOBI BENCHTOP BELT/DISC SANDER.Your new Belt/Disc Sander has been engineered and manufactured to Ryobi's high standards

104 x364 x36ASSEMBLYASSEMBLING WORK SUPPORTSee Figure 8. Place the work support over the holes in the side of thetool housing. Using a hex key, fast

114 x364 x36ADJUSTMENTSWARNING:Before performing any adjustment, make sure the belt/disc sander is unplugged from the power supply and theswitch is in

1201545OPERATIONFig. 14TABLELOCKKNOBBEVEL SANDINGSee Figure 14.The worktable can be tilted from 0° to 45° for bevel sanding.To tilt the worktable: Lo

134 x36Fig. 174 x36WORKSUPPORTWORKPIECEFig. 18WORKPIECEOPERATIONSURFACE SANDING ON THE SANDING BELTSee Figure 17. Hold the workpiece firmly, keeping

14MAINTENANCEFig. 20WARNING:When servicing use only identical Ryobi replacementparts. Use of any other parts may create a hazard or causeproduct damag

15NOTESNOTES

983000-017 11-02RYOBI TECHNOLOGIES, INC.1428 Pearman Dairy Road Anderson, SC 29625Post Office Box 1207 Anderson SC 29622-1207Phone 1-800-525-2579w

2Table Size 8 1/2 in. x 5 3/4 in. (215.9 mm x 146 mm)Table Tilt 0°-45°Input 120V AC, 60Hz, 4.3 ampsMotor 1/2 HP InductionNet Weight 53 lbs (24 kg)Look

3RULES FOR SAFE OPERATIONSafe operation of this power tool requires that you read andunderstand this operator's manual and all labels affixed tot

4RULES FOR SAFE OPERATIONSAVE THESE INSTRUCTIONS ALWAYS TURN SWITCH OFF before disconnecting it toavoid accidental starting. ALL REPAIRS, WHETHER EL

5RULES FOR SAFE OPERATIONIMPORTANTServicing requires extreme care and knowledge and shouldbe performed only by a qualified service technician. Forserv

6ELECTRICALEXTENSION CORDSUse only 3-wire extension cords that have 3-prong ground-ing plugs and 3-pole receptacles that accept the tool's plug.W

7UNPACKINGYour belt/disc sander has been shipped completelyassembled except for the sanding disc, disc guard, mitergauge, work support, and worktable.

84 x36FEATURESFig. 3SANDING DISCA round sanding disc located on the side of the belt/discsander.SWITCH AND SWITCH KEYYour disc/belt sander has an easy

94 x364 x364 x36Fig. 4Fig. 6ASSEMBLYINSTALLING SANDING DISC AND DISC GUARDSee Figure 4.WARNING:Do not connect to power supply until assembly is comple