Ryobi BD4600 Betreibershandbuch PDF herunterladen (Seite 10)

4 x36

ASSEMBLY

ASSEMBLING WORK SUPPORT

See Figure 8.

■ Place the work support over the holes in the side of the

tool housing.

■ Using a hex key, fasten in place with the washers and

socket head screws.

MOUNTING BELT/DISC SANDER TO WORK-

BENCH

See Figure 9.

If your belt/disc sander is to be used in a permanent location,

it is recommended you secure it to a workbench or other

stable surface. When mounting the belt/disc sander to a

workbench, holes should be drilled through the supporting

surface of the workbench.

■ Mark holes on workbench where belt/disc sander is to be

mounted using holes in the base as a template for hole

pattern.

■ Drill holes through workbench.

■ Place belt/disc sander on workbench aligning holes in the

base with holes drilled in the workbench.

■ Insert bolts (not included) and tighten securely with lock

washers and hex nuts (not included).

Note: All bolts should be inserted from the top. Install the

lock washers and hex nuts from the underside of the

workbench.

CLAMPING BELT/DISC SANDER TO WORK-

BENCH

See Figure 10.

If your belt/disc sander is to be used as a portable tool, it is

recommended you fasten it permanently to a mounting board

that can easily be clamped to a workbench or other stable

surface. The mounting board should be of sufficient size to

avoid tipping while belt/disc sander is in use. Any good grade

plywood or chipboard with a 3/4 in. (19 mm) thickness is

recommended.

■ Mark holes on board where belt/disc sander is to be

mounted using holes in the base as a template for hole

pattern.

■ Follow last three steps in section

Mounting Belt/Disc

Sander to Workbench.

If lag bolts are used, make sure they are long enough to go

through holes in belt/disc sander base and material the belt/

disc sander is being mounted to. If machine bolts are used,

make sure bolts are long enough to go through holes in belt/

disc sander, the material being mounted to, and the lock

washers and hex nuts.

Fig. 9

MOUNTING

BOLTS

Fig. 8

WORK

SUPPORT

SOCKET

HEAD

SCREWS

WASHERS

Fig. 10

MOUNTING

BOLTS

HEX NUT

LOCK

WASHERS

HEX NUT

LOCK

WASHERS

MOUNTING

BOARD

C-CLAMPS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Ryobi BD4600 Betreibershandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Ryobi BD4600