Ryobi HP37 Bedienungsanleitung PDF herunterladen (Seite 9)

9 — English

WARNING:

Do not allow familiarity with products to make you

careless. Remember that a careless fraction of a second

is sufficient to inflict serious injury.

WARNING:

Always wear safety goggles or safety glasses with side

shields when operating products. Failure to do so could

result in objects being thrown into your eyes, resulting in

possible serious injury.

APPLICATIONS

You may use this product for the purposes listed below:

Driving screws with screwdriver bits

Light-duty drilling

WARNING:

Battery products are always in operating condition.

Therefore, the switch should always be locked when not

in use or carrying at your side.

TO CHARGE

See Figure 2.

This tool has been shipped in a low charge condition to

prevent possible problems. Therefore, you should charge it

overnight prior to use.

NOTE: Batteries will not reach full charge the first time they

are charged. Allow several cycles (driving screws followed

by recharging) for them to become fully charged.

NOTE: This power unit is intended to be correctly oriented

in a vertical or floor mount position.

If the charger does not charge the screwdriver under normal

circumstances, return both the screwdriver and charger to

the nearest authorized service center for electrical check.

TO CHARGE SCREWDRIVER WITHOUT

USING CHARGING STAND

See Figure 2.

 Insert charger plug into input jack making sure they are

properly connected.

 Charger can be used with normal household voltage

of 120 volts, AC only, 60 Hz.

 Connect charger to power supply.

 After normal usage, a minimum of 10 hours of charging

time is required to fully charge screwdriver.

 Do not place charger in an area of extreme heat or cold.

It will work best at normal room temperature.

OPERATION

CHARGER

PLUG

CHARGER

INPUT

JACK

Fig. 2

BACK SIDE Of CHARGING STAND

2-5/8 in.

SLOT

CHARGING

STAND

CHARGER

CHARGING

PLUG

Fig. 3

WALL

ANCHORS

PILOT

HOLES

SCREWS

CHARGING STAND

Fig. 4

BIT STORAGE

BIT(S)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Ryobi HP37 Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Ryobi HP37